I am selling a new 222000Btu/Hr 480V Up to 40000 Gallons Commercial Pool Heater for Swimming Pools, SPA Pools, and Bathtubs,SPA Water Bath Heater Thermostat Swimming Pool Thermostat Heater Pump.
This was a returned item due to shipping damage on the casing as you can see .
I opened the panels and inspected and cannot find and damage to components, etc.
, see pictures.
There are no signs of use at all.
About this item
1.
220,000 BTU/ hr 480V in coastal climates,the temperature ranged from 71.
6 °F-122 °F (22 °C-50 °C)
Suitable for 40,000 Gallons -300 sqft In ground Pools, 27' Round-18 x 33 Oval Above ground pools ( Long Island NY- Corpus Christi TX) .
If you are not sure about your area's suitability or performance rating, please sned us your zipcode and pool size and we will size it for you.
3.
Designed, Engineered, Manufactured and Serviced by Coasts
4.
Suitable for ALL Hot Tubs,Above Ground Inground Pool Swimming Pool.
5.
54KW,60 HZ American Voltage.
Wired To three Phase 40A GFCI,Use With Water Pump.
222000Btu/Hr 40000 Gallons Swimming Pool Heater for Swimming Pools, SPA Pools,and Bathtubs,SPA Water Bath Heater Swimming Pool Thermostat Heater Pump
Swimming Pool fit for Thermostat Pool fit for Thermostat Heater Pool SPA Bath Hot Tub Electric Water Heater fit for Thermostat Introduction: Fit for Thermostat is designed specifically for the needs of the Jacuzzi and swiming pool, the fit for thermostat installed in the bottom of the tub on the massage tub, after adding hot water in the bath, start the water pump, the fit for thermostat automatically heating insulation, the bath water temperature maintained at 30-40℃ adjustable, it can give your massage bathtub to create a comfortable environment.
Normal Operation: The operation of the fit for thermostat is fully automatic.
When installed properly it will turn ON after user have set the temperature by turning the controlling switch clockwise, then the heating-up indicator turns on.
As long as the fit for thermostat is on, it will heat up the water to the user-set level and maintain the temperature.
User can turn the controlling switch anticlockwise to a temperature lower than the current water temperature to turn OFF the fit for thermostat, and the heating-up indicator turns off.
There is no separate heat controller for user.
P.
S:Please refer to the instruction manual for specific installation procedures,thank you !! Note: Do not allow any electrical appliances (such as lights, telephone, hair dryer, radio or television) in the bathtub, 1.
5 meters (5 feet) or less.
The fit for thermostat should not be used in salt water, acidic water or alkaline water, can not be used in other places chemically corrosive gases or solvents.
Fit for Thermostat outlet to
the bath tub in the middle of the pipe or valve or check valve can not be install.
Package Content 1 x Water Heating Thermostat 2 x Interface 1 x Manual
Whatsapp
